Run the arms under warm water to make them easier to adjust. If your hinge is simply bent and not broken, with careful manipulation you can bend it back to its original position.
You could fix that in about 30 seconds with a pair of needle nose pliers, a vice or vice grips, a towel, and a steady hand.
How to fix bent glasses arms. Thanks for the advice, i'll go to a glasses store soon to see if they can fix it. With your left hand, hold. If your right lens is closer in:
Bend each arm up or down where it meets the frame, moving the arms a tiny bit at a time until they are in the correct position. If your glasses are crooked (lens sitting higher on one side) you will need to heat up the frame a little and bend the arms downwards on the lowest side. I guess this is their way of winning your business next time you order glasses.
This is just one of many things you can do to adjust glasses. Broken glasses are a lot more expensive to fix than ones that are simply bent. Make sure the cloth is unwrinkled so you can see how the glasses bend underneath it.
If the left side is higher than the right: Bend the left temple arm in and/or the right temple arm out at the hinge. Bend the right temple arm in and/or the left temple arm out at the hinge.
Use the towel to cushion the lens, mount the lens in the vice/vice grips, and very slowly and very gently bend the metal back into shape. You should do this at the hinge or the bend by the ear where the frame is most adjustable. How to fix bent glasses with metal frames.
Make sure the cloth is unwrinkled so you can see how the glasses bend underneath it. Adjust the arms at the temple to remedy glasses that slide down your nose or aren’t level on a flat surface. Be sure not to apply too much pressure or use quick, jerky movements.
Only use water as warm as you can get from the tap. To bend them back in to shape, all you need is a little hot water to soften up the plastic a bit. This could be a hankie or a cloth napkin.
Gently bend the right arm down at the hinge or where the arm bends behind your ear. You can bend them with your fingers or use a small pair of pliers to gently adjust the arms. Rotate the glasses so that the bent arm is directly in front of you.
Place a thin cloth over the glasses to prevent them from getting damaged. Do not use wire cutters. For wire frames, gently bend the arms with small pliers until they are straight.
If your left lens is closer in: If the right lens is higher than the left lens: This could be a hankie or a cloth napkin.
Adjust frames a little bit at a time to avoid overcompensating and possibly damaging your glasses. To fix metal frames, there are two things you’ll need: If it's unclear which way they need to be bent in order to straighten them, place the glasses on a table or other flat surface.
Position the pliers over the bent section of the frames. Put the glasses on and observe in the mirror to see if they are correct. You must use padded pliers or the frames will likely be damaged.
Apply only the minimum amount of force needed to ensure that you don't break the arms. Place a thin cloth over the glasses to prevent them from getting damaged. Do not use boiling water!
Open the arms of the glasses as if you were going to wear them. I'll have more videos as i get different kinds of repairs and adjustments coming in. Plastic frames need to be warmed before they can bend.
Everyone's had a pair of sunglasses that over time warped so they didn't rest comfortably anymore. If you live in the us, take it to a walmart optical center and they’ll typically bend the back into shape free. I had a midrange pair of titanium frames with regular hinges, and they were easier to fix.
Repeat for the other arm. Inspect the hinge and make sure it’s the one that flies apart. Hold them securely but not too hard as you adjust the glasses.
You can warm the glasses in hot water for about 30 seconds or with a hairdryer, but be careful not to overheat. *while your glasses are strong, be careful not to apply excessive force.