You'll have to move all the electrical boxes out to the new surface, and if you're installing around a door or window, you'll. The second is that the white tone is suitable for the porch color scheme.
First pro quality carpentry started by installing wood furring strips to the existing stucco ceiling and made sure to attach the furring strips to the wood support trusses underneath the stucco.
How to install tongue and groove ceiling over stucco. Make sure end joints are staggered from row to row. We’ve had this ceiling for more than 10 years now with zero issues. Once you’ve installed your tongue and groove wall paneling, you can move on to the ceiling.
Then we installed the t&g ceiling to the rafters, like in the photo below: Secure the first row by nailing into the tongue to the joist, (or furring strip) and secure the groove side of the plank by face nailing into the joist. Gary b on aug 31, 2017.
And use existing studs/rafters to mount each piece of paneling. Depending on the t&g manufacturer's recommendations, you may need to apply a coat of construction adhesive to the back of the plank before nailing it in place. Also.make sure you use long enough nails.figure the t&g is 3/4.your ceiling drywall is at least 5/8 + texture (assume 3/4 total).
Insert the nails into the tongue at an angle and use enough force to have the nail flush with the surface of the tongue. To be sure.take a drywall sanding block and run it over the entire ceiling to remove any high spots. One option would have been to install the tongue and groove boards on top of the existing drywall ceiling, but we suspected there were a couple of layers and we could gain some height, instead of losing it.
The most common method for installing tongue and groove ceilings is with a nail gun, fastening each board to every ceiling joist with 2 nails shot into the joist at slightly opposing angles. Any remaining cracks are caulked. Quarter round trim added to cover expansion gap and finish ceiling edges.
In hindsight, it was worth it. You’ll start from one corner. The foam completely fills the rafter bays, as in the photo above.
Continue attaching the t&g in the second row. The first is that it has a white color. Removing the plaster is the best but to overlay it you will first have to lathe.
Remember to stagger the joints as. You'll remove staples left over from shipping wrap, cut away any splits and get clean, square edges. Before installing the planking shim the lathe so that the final result will not have waves.
If the final board is narrow, join it to the second to last board and install the two together. Slide the groove of a board over the tongue of the first board to start the second row on either side of the ceiling. Next they installed our tigerwood nickel gap tongue and groove and fastened to the furring strips with stainless steel screws through the tongue to leave the ceiling free of faster holes.
If you’re planning to install your own ceiling, you’ll need a few tools. The process here is almost exactly the same. Installing cedar tongue and groove porch ceiling.
Prep the tongue and groove board ends. Learn to install a tongue and groove ceiling with this quick and east dyi tutorial. No vapor barrier required with closed cell polyurethane.
Attach tongue and groove board to saw horses using deck screws as holder for final beaded board to be ripped with circular saw. I would use 1×4 on 24 inch centers and long screws to hold them in place. You want a min of 1 penatration into the ceiling joist.so your looking at a 2 1/2 finishing nail.
Maintain a slight gap around the walls to allow for expansion. Tongue and groove headboard is an easy upgrade that will add curb appeal. Installing a tongue and groove ceiling.
With a color like this, it is possible for the tongue and groove boards, if it is from wood, to undergo a painting process before the installation. Recut the ends of every board. There was a layer of.